This is the Gmade GS02 BOM Ultimate Trail Truck 1/10 Scale Electric Powered Ready-to-Run Truck. The GS02 BOM is built on a scale-looking ladder frame construction with stand-up front shock and lay-down rear dampers that make way for the scale roll cage construction. The steering servo is located in the front part of the chassis and the steering assembly is of a zero-Ackermann design for maximized steering performance. Angled front king pins minimize the scrub radius for further increased steering efficiency. The heavy-duty threaded aluminum shock absorbers utilize 3.5mm shock shafts and the transmission, with all-metal internal gears, is of a torque twist reducing design. Optionally a 2-speed hi/lo transmission conversion will become available to add speed when needed. The kit is rounded out by grippy tires, a cool looking body shell, a couple of scale accessories.
Width: 230mm (9.05")Height: 220mm (8.66")Length: 515mm (20.28")Wheel Base: 313mm (12.3")Ground Clearance: 73mm (2.87")Weight with no electronics: 2.1kg (4.6lb)Tx Channels: 2-ChannelTx Antenna Length: 26mm (1.02")Tx Dimensions: 210mmx95mmx160mm (8.26"x3.74"x6.3")Tx Weight: 239g (8.43oz)Tx Power: 6V DC (1.5V AA x 4)Rx Channels: 3-ChannelRx Antenna Length: 140mm (5.51")Rx Dimensions: 35mmx22mmx12mm (1.37"x0.87"x0.47")Rx Weight: 5g (0.17oz)Rx Power: 4.0-6.5V DCFrequency: 2.4GHzRF Range: 2.405-2.475GHzRF Power: <20dBmRF Receiver Sensitivity: -98dBmBand/Bandwidth: 141/500KHzCode Type: GFSKSensitivity: 1024ESC Cont. Current (Forward/Reverse): 40A/20AESC Burst Current (Fwd/Rev): 180A/90AESC Input Power: 2-3S LiPo or 5-9 Cells NiMHESC Motor Limit (2S LiPo/5-6 Cell NiMH): 540/500 size motor ≥12T or RPM <30000 @ 7.2VESC Motor Limit (3S LiPo/7-9 Cell NiMH): 540/500 size motor ≥18T or RPM <20000 @ 7.2VResistance (Fwd/Rev): 0.002 Ohm/0.004 OhmBuilt-In BEC: 2A/6V (Linear mode BEC)ESC Dimensions: 46.5mmx34mmx28.5mm (1.83"x1.33"x1.12")ESC Weight: 70g (2.46oz)Motor Type: 27 Turn 540-sizeMotor Shaft Diameter: 3.1mm (0.12")Motor Shaft Length: 12mm (0.47")Motor Can Diameter: 36mm (1.42")Motor Can Length: 50mm (1.97")Servo Dimensions: 40.7mmx20.5mmx39.5mm (1.60"x0.81"x1.56")Servo Weight: 60g (2.11oz)Servo Input Voltage: 6.0VServo Stall Torque: 13.2kg/cmServo No-Load Running Speed: 0.14sec/60°Servo Storage Temp: -20C ~ 60CServo Dead Band Width: 4us